This unique system completely removes airflow from damaged glass and fills it with a special connecting mass with glass. Adhesive hardens to affect sunlight. In the final version, this mass becomes completely transparent, making the place invisible. The kit is composed of: 1. Pedestal. 2. Syringe  3. Glue 4. Sealing tape. 5.  hardening tape. 6. Blade. 

Usage: 1. Thoroughly clean the damaged glass. Carefully scan for any glass splinters and other particles using wet paper or paper. 2. Remove the protective film from one side of the sticker and seal it on the desired glass area to coincide with the damaged glass. the tab must be facing up. 3. Remove the protective film from the upper side of the sticker. 4. touch the pedestal with a pre-sealed sticker to match the two contours, make sure that it has glued firmly. 5. Open the package with glue, and lightly squeeze so that a little bit of glue comes out. Clean the excess glue with a cloth and leave the prepackaged adhesive until step 11. 6. Connect the syringe with the pedestal. Make sure that the syringe with the pedestal, make sure that the syringe is fully depressed (there is no air in the syringe). Press the syringe firmly. Make sure that the syringe with the pedestal is firmly held. 7. While holding with one hand, gently pull the syringe to remove bubbles from the adhesive. Leave the syringe in this position for 10minutes.  8. Insert the plug from the syringe to allow the air to enter and reinsert the plug again. 9. Bracing syringe with one hand push the foot of the syringe to the first cut edge to pressurize., clamp in position shown in Figure 9. and leave for 20mins. 10. Carefully remove the glass pedestal and adhesive residues from the blade shown in Figure 10. 11. Place the curing strap on the affected area and apply a drop of glue, and suddenly turn it over and place it on the affected area. As shown in the pciture. 12. Carefully remove all air bubbles from the strip under the blae using a blade. The glue starts to work under the influence of sunrays passing throigh the strip. Place the car in the sunlight for 15minutes. On a cloudy day the drying process will take one hour. Once the glue is hardened remove the hardening tape and remove remaining adhesives using a blade.